Shure PSM 1000 Guia Del Usuario página 8

Utility Settings
Channel Name
Util > Channel Name
Turn control wheel to change channel name. You can set a different name for each channel on the device (this name is
uploaded to the bodypack with sync).
Display Settings
Util > Display
Change the look of the LCD panel from the display menu.
Brightness
Sets display brightness to high, low, or medium.
Disp. Invert
Changes display from light on dark to dark on light.
Contrast
Use the control wheel to adjust contrast.
Interface Locks
Use these controls to lock or unlock power switch and front panel controls.
Power Switch
Util > Lock > Power Switch
Locked
Locks power switch.
Off
Unlocks power switch.
Front Panel
Util > Lock > Front Panel
Locked
Locks the controls on the front panel for the selected transmitter.
Off
The front panel is unlocked.
Unlocking Front Panel
To unlock the front panel, select Util > Unlock
Network Setup
Use this menu to find, display and change how this device connects to the network. There is one set of network settings
for both transmitters.
Device Identification (Device)
Allows you to assign a display name. This applies to both channels on the device. To name each channel individually,
use the Channel Name setting.
Setup (Mode)
Automatic
Default setting for use with DHCP networks.
Manual
Manual IP addressing. Allows you to enter an IP address (IP) and subnet mask (SUB).
MAC
Displays MAC address for this device, view only, and there is only one MAC address for both transmitters.
Reset
Manual mode only. Resets network settings to the factory defaults.
Find All Network Devices (Find All)
Lists all network devices.
• Scroll to any of the listed devices and press Show Info to view information about that device.
• Press Flash to flash the LEDS of all devices on network
• Press Back to return to previous screen
Additional Settings (More)
Product ID
Displays product serial number.
Reset All
Restores the values on all networked devices to factory default settings.
FW Update
Displays the receiver firmware version that is currently stored in the transmitter. Press Download to transfer the
update to a receiver through the IR port.
6