Audio Settings - Shure PSM 1000 Guia Del Usuario

Bodypack Receiver
RF Settings
Access the following RF settings from the RADIO menu.
G
Group number. Each group contains channels selected to work well together in a single
installation.
CH
Channel number. Sets the receiver to a channel in the selected group.
888.888 MHz
Displays the frequency to which the transmitter is set. Highlight and use the ▼▲ buttons
to set the transmitter to a specific frequency.
SQUELCH
Adjusts the squelch setting.
FULL SCAN
Performs spectrum scan and displays open frequencies in a graphical interface.
RF PAD
Attenuates antenna signals in 3 dB increments.
ANTENNA
Selection for single antenna operation. Disables diversity reception.
Utilities and Display Settings
Access the following settings from the UTILITIES menu.
CUEMODE
Enters CUEMODE to exit, press enter and select EXIT CUEMODE
DISPLAY
Change the display settings on the bodypack
CONTRAST
Sets display brightness to high, low, or medium.
LOCK PANEL
Locks all controls except power and volume.To unlock, press exit, select OFF, and
press enter.
BATTERY
When using an SB900 - Shure rechargeable battery, the following information is dis-
played: Hrs: Min Left, temperature, Status, Cycle Count, and Health.
RESTORE
Returns receiver to factory default settings.
① Power Switch and Volume Control
Turns the bodypack on and off and adjusts earphone volume.
② 3.5 mm Earphone Jack
Insert earphones here.
③ Scan Button
Press the scan button to find an available frequency. Press and hold for
two seconds to find the group with the most available channels.
④ IR Window
For transmitting settings between bodypack and rack unit.
⑤ Battery Compartment
Requires 2 AA batteries or Shure rechargeable battery. Open by pressing
the latches on both sides and pulling.
⑥ Menu buttons
Use in conjunction with the ▼▲ buttons to access the configuration
menus.
⑦ ▼▲ Buttons
Use to adjust the audio mix (in MixMode only), or in conjunction with the
menu buttons to change settings.
⑧ LCD Screen
Displays current settings and menus.
⑨ Tri-Color Battery LED
Illuminates green, amber, or red to indicate battery power. When red,
change battery immediately.
⑩ Blue RF LED
Indicates the bodypack is receiving a signal from the transmitter.
⑪ SMA Connector
For detachable antennas.
⑫ Removable AA Adapter
Remove to use with a Shure SB900 rechargeable battery.
Note: To remove adapter, open door and slide out. To reinstall adapter,
place over the clip and press, there will be an audible click when seated.

Audio Settings

Access the following audio settings from the Audio menu.
Output Mode (MODE)
STEREO
Stereo
MIXMODE
MixMode
High-Frequency EQ Boost (HIBOOST)
OFF
No boost (flat).
4 dB
4 dB boost at 10 kHz.
2 dB
2 dB boost at 10 kHz.
Volume Limiter (V LIMIT)
V LIMIT
Turns limiter on (ON) or off (OFF) .
VALUE
3 to 9: If the limiter value is set to a certain position (5, for example), the
sound will not increase if you turn the volume knob to a position higher
than 5. The volume limit does not compress the audio signal.
Output Gain (GAIN)
HIGH
Increases gain by 10 dB
STANDARD(STD)
0 dB of gain.
7