Menu Navigation - Shure PSM 1000 Guia Del Usuario

Menu Navigation

Radio Frequency (RF) Settings
Access the Radio menu to adjust the frequency and power at which the unit operates.
G
Group number. Each group contains channels selected to work well together in a single installation.
Ch
Channel number. Sets the transmitter to a channel in the selected group.
888.888 MHz
Displays the frequency to which the transmitter is set. Frequency selection; adjustable in increments of 1MHz or 25kHz.
PWR
Power level at which the transmitter operates. Select from 10, 50, or 100 mW (power levels vary by region).
Custom
For creating custom frequency groups. See Custom Groups.
Audio Settings
Access the following settings from the Audio menu.
Input Level (Input)
This changes the audio level for the inputs on the back of the rack transmitter.
Line
+4 dBu (line level)
Aux
–10 dBV (aux level)
Audio Mode (Mode)
Stereo/MX
Transmits each input as a separate channel.
Mono
Combines both inputs into a single channel.
PTP
Set up the device for point-to-point wireless audio.
Output Level (Level)
Adjust output level.
Receiver Synchronization Menu (Sync)
Transferring Settings to the Bodypack During
Sync (RxSetup)
Use this feature to store settings that will be transferred to the
bodypack during a sync.
Each parameter has the default value NoChange, which leaves that
setting unaffected by a sync.
Lock
ON: Locks the bodypack interface.
Off: Unlocks the bodypack interface.
V Lim
ON: Turn volume limit on.
Off: Turn volume limit off.
Lim Val
Sets value for volume limit.
HiBoost
Sets value for high frequency boost.
Mode
Sets stereo (ST) or MixMode (MX).
Bal Mx
Sets balance for MixMode.
Bal St
Sets balance for stereo mode.
Downloading and Viewing Spectrum
Scan Data (Spectrum)
Align the receiver and transmitter IR ports and press
SyncScan to download spectrum scan data from the
receiver.
After downloading data, the following options are
available:
Deploy
Enters a submenu from which you can deploy open
frequencies to all transmitters on the network.
Cursor
Enables the control wheel to move the cursor.
Zoom
Enables the control wheel to zoom into graphic at
cursor position.
Tip: Push the control wheel to toggle between cursor
and zoom modes.
Sync
Press to sync the receiver and transmitter using the
IR port.
RADIO
G
CH
888.888MHz
RF POWER
Custom
Load
Clear
Next
AUDIO
Input
Line
Aux
Mode
Stereo/Mix
Mono
PTP
Level
SYNC
RxSetup
Lock
V Lim
Lim Val
Hi Boost
Mode
Bal Mx
Bal St
Spectrum
Sync Scan
Deploy
Cursor
Zoom
Sync
Retry
OK
5