Bosch FlexiDome XF Serie Manual De Instalación página 16

FlexiDome
XF & DN
Heater
When using the camera at low temperatures, select the heater setting to
"Auto" in the Installer Menu (see Menu Structure).
Closing the unit
When the camera position is set and all adjustments have been made, close
the unit.
• Place the inner liner in position aligning its fin with the bracket on the
base.
• Place the dome onto the base and rotate until it clips into place. (If
necessary clean its surface with a soft cloth.)
• Place the sealing ring and the trim ring over the dome.
• Align the tamper resistant screws in the trim ring with a thread holes in
the mounting base.
• Use the special screwdriver supplied to tighten the three tamper
resistant screws.
Bosch Security Systems | 2005-10 | V1.0
| Installation Manual EN | 15