Install Id Submenu; Defaults Submenu; Camera Control Communication - Bosch FlexiDome XF Serie Manual De Instalación

FlexiDome
XF & DN

Install ID submenu

Function Selection
CAMERA ID
ID POS OFF, TOP, BOT
EXIT

Defaults submenu

Function Selection
ALL
DEFAULTS
EXIT

Camera Control Communication

This camera is equipped with a coaxial communications transceiver. In
combination with VP-CFGSFT, the camera can be adjusted from the head-
end side of the coaxial cable. All menus can be accessed remotely giving
full control of the camera. With this communication it is also possible to
disable the local keys on the camera.
To avoid loss of communication on an installed camera, the
COMMUNICATION ON/OFF selection is NOT available while using
remote control. This function can only be accessed with the camera
buttons.
Bosch Security Systems | 2005-10 | V1.0
| Installation Manual
Description
Enter a 16 character camera name string. Use
LEFT/RIGHT to change position in the string, use
UP/DOWN to select the character. Use SELECT
to exit the string edit screen.
Select TOP to display the camera ID in the upper
left corner; select BOT for the lower left corner.
The ID string is not displayed when the OSD
menus are open.
Return to the Install menu
Description
Select to restore the factory defaults. A
confirmation screen appears. Allow 5 seconds for
the camera to optimize the picture after a mode
reset.
Return to Install menu
EN | 27