V2 VEO-RFE Serie Manual De Instrucciones página 19

INSTALLATION
• Fix the stirrup G to the wall.
• Insert the crown A in the driving wheel B of the limit switch
(fig.1).
• Insert the pulley C on the pivot of the motor D (fig.1).
Insert the copper pin F on the pulley C.
•
• Insert completely the motor in the roll-tube (fig.2).
• Fix the roll-tube to the driving wheel with m 4 x10 screw (fig.2).
• Insert the pin E into the bracket G
DESCRIPTION
This opening system is made of a tubular motor with built-in
control unit with the following characteristics:
• It is provided with a 434.15 MHz super-heterodyne radio
receiver.
• Up to 48 different channel can be stored on each central unit.
• It is driven by means of transmitters PROTEO, DUO, ARTEMIS,
ADLER and DEV-T1.
• It is possible to drive the awning / rolling shutter also by mean
of an external push-button (type: Normally Open, each series
or model).
• The programming phase can be effected via radio or by means
of an external switch.
• Obstacle detection (only with rolling shutters with SICUR
BLOCK): if during the closing phase of the rolling shutter
an obstacle is detected, the device opens the rolling shutter
completely.
FUNCTIONING WITH EXTERNAL WIRED
SWITCH
Pressing the external wired switch, the control unit has the
following functioning logic:
a a
OPENS STOPS CLOSES
FUNCTIONING WITH TRANSMITTERS
At each push button pressure, the functioning logic is the
following.
a
UP: CLOSES CLOSES
a
STOP: STOPS STOPS
a
DOWN:
OPENS OPENS
WORKING TIME OF MOTOR
The control unit stops the motor movement after 5 minutes: in
case of limit switches malfunction this "time out" avoids the
motor overheating.
a a
STOPS OPENS ...
a
CLOSES
a
STOPS
a
OPENS
TRANSMITTERS OF THE RANGE
PROTEO / DUO
Using a transmitter of the range PROTEO / DUO it is possible
changing the functions of the control unit controlling the tubular
motor.
The transmitter is equipped with a 10 switches dip-switch thanks
to which it is possible to change the desired functions: set on ON
the switch corresponding to the function required and follow
carefully the dedicated procedure.
WARNING: all the other switches have to be set on OFF
SWITCH FUNCTION
1
Storage of the transmitters and selection of the
mode awning
2 Storage of the transmitters and selection of the
mode rolling shutter
3 Deletion of all the stored transmitters
4
Programming of the upper position of
end-of-stroke sensor
5
Programming of the lower position of the
end-of-stroke sensor
6 Programming of the middle position of the
end-of-stroke sensor
7-8-9-10 NOT USED
- 19 -
DIP-SWITCHES
PROG