Urrea DM60 Manual De Instrucciones página 14

OPERATION
The digital laser distance meter is a preci-
sion instrument. Please observe the following
guidelines to ensure optimal performance.
• Do not direct the digital laser distan-
ce meter towards the sun or other sour-
ce of bright light. This may cause an Error
reading or inaccurate
• Do not operate the digital laser distance
meter in wet, dust, sandy or other adverse
environments, Such conditions may damage .
• Inner components and affect measuring ac-
curacy.
• When the digital laser distance meter is
brought into a warm environment from very
cold conditions, or vice versa, allow it to come
to the surrounding temperature before use.
• Measuring errors can occur when mea-
suring toward colorless
water), clean glass, Styrofoam, or simi-
lar translucent or
• High-gloss surfaces will deflect the laser
beam and result in Error measurements.
• Very bright surroundings
with a very low reflecting surface will re-
duce the measuring range and accuracy.
• Do not immerse the tool in water, Wipe off
dirt with a damp, soft cloth. Do not use ag-
gressive cleaning agents or solutions. Treat
the optical surfaces with the same care that
you would apply to eyeglasses or cameras.
• The accuracy of the tool must be chec-
ked before use after it has been dropped
or subjected to other mechanical stresses.
TO INSTALL BATTERIES (Fig. 3)
This digital laser distance meter uses three
"AAA" batteries.
1. Push the hook to open the battery cover, in-
sert three "AAA" "alkaline batteries according
to the polarity indicators in the battery com-
partment. Be sure the polarity (+/-) is correct!
2. Close the cove and lock it securely in place.
NOTE:
• Replace the batteries when the battery indi-
cator shows empty.
• Remove the batteries from the measuring
tool when not suing it for extended periods.
• The 3 AAA batteries immediately and dispo-
se of them according to your local ordinance.
measurements.
liquids (e.g.
low-density materials.
combined
Never dispo-
se of batte-
ries in fire.
• Do not mix
old and new
b a t t e r i e s .
• Remove
dead batteries
immediately,
and dispose
of them accor-
ding to your
local ordinan-
ce. Never dis-
pose of batteries in fire.
TO TURN THE DIGITAL LASER DISTANCE ME-
TER ON AND OFF.
key to turn on the tool, the tool will
1. Press
default to the single-distance measuring mode,
indicating that the tool it is ready to take mea-
surements.
2. Press ckey about 2 seconds to turn off
the tool.
3. When the measuring tool is inactive for 5
minutes, it will automatically turn off to save
battery power.
TO CHANGE MEASURING REFERENCE POINT
The default reference setting is from the rear
of the tool. By pressing
setting can be changed among the position of
the front of the tool, the rear of tool. So the
next measurement will be taken from the po-
sition you set.
After powering off, the reference point will
automatically default back to rear.
TO CHANGE THE UNITS/TURN ON AND TURN
OFF THE BACK TO LIGHT OF LCD
Press , key, the back to light of LCD can be
turned on and turned off, At dark environ-
ment user may turn on this function at any
tine, The measuring data will be displayed
clearly on LCD press
about 3 seconds to change the measurements
units among m, ft, in, ft+/in.
TO TAKE MEASUREMENT
Hold the tool at the point from which you
want to measure, Press
laser, press it again to take a measurement.
Fig. 3
key repeatly, the
key and hold it for
key to turn on the
14