Mantenance; Troubleshooting - Urrea DM60 Manual De Instrucciones

History member data
1. Press key to choose history member data
mode.
2. Hold on to press
history data.
3. Continue to press
de mediciones serán mostrados sucesivamente
en la pantalla LCD.
4. Press key to exit the history record sta-
te, the tool will return the single measurement
mode.

MANTENANCE

This digital laser distance meter has been de-
signed to be a low-maintenance tool. Howe-
ver, in order to maintain its performance, you
must always follow these simple directions.
1. Always handle the tool with care. Treat it as
an optical device, such as a camera or binoculars.
2. Avoid exposing the tool to shock, continuous
vibration or extreme hot or cold temperature.
3. Always store the tool indoors,when not in use.
Always store the tool in its protective case.
4. Always keep the tool free of dust and li-
quids. Use only a clean, soft cloth for cleaning.
If necessary, slightly moisten the cloths with
pure alcohol or a little water.
5. Do not touch the lens with your fingers.
6. Check the batteries regularly to avoid dete-
rioration.
Always remove the batteries from the tool, if it
is not going to be used for an extended period
of time.
PROBLEM
Tool cannot be switched on
The tool emits "click" when
tale a measurement
Error codes on LCD in
measuring
can delete the current
, los últimos 20 grupos
CAUSE
Batteries
incorrectly
Batteries are low voltage
The Power did not contact
well
It is the shift of optical path
inside, normal
Please refer to the part of
"Error signals" above
7. Replace the batteries when the battery icon
is continuously empty displayed on the LCD.
8. Do not disassemble the laser; this will expose
the user to hazardous radiation exposure.
9. Do not attempt to change any part of the
laser lens.

TROUBLESHOOTING

The following error signals may appear on the
LCD of your tool during measuring:
ERROR
CODE
ERR01
ERR02
the measuring
ERR03
ERR06
SOLUTION
are installed Reinstall
according to the polarity
indicators
compartment
Replaced with new batteries
Try to press it with a bigger
force of send for repair
N/A
Please refer to the part of
"Error signals" above
ERROR SOLUTION
CAUSE
The reflected Do not direct
laser light is the laser at
too intense. a highly
reflective sur-
face; cover the
surface with
white paper if
necessary.
Out of range, Take measu-
rement within
range for this the range of
tool is from 0.05-60m.
0.05-60m
The target Change the
provides poor measuring tar-
reflection of get or cover it
the laser. with a piece of
white paper.
Low battery Insert new
a reminder to batteries.
replace the
batteries.
the batteries
in the battery
18