Urrea DM60 Manual De Instrucciones página 15

NOTE:The laser will switch off after 20 seconds
of inactivity. If a measurement has not been
make within the previous 20 seconds, push
key again to turn on the laser.
WARNING: Do not point the laser dot at
persons or animals and do not stare into the
laser beam or view directly with optical instru-
ments.
CLEAR FUNCTION
Push key to erase the current measure-
ment and display the previous measurement.
In Area, Volume and Pythagorean Theorem
measurement mode continuously press the
clear key to go back to the single distance mea-
ser at the target you
want to measure.
3.Press key again to
take a measurement.
4. The result of measu-
rement is shown in the
lowest row of the screen
in large numerals, and
the laser beam switches
off.
5. To take a second mea-
surement, Press
to turn on the laser
again, and the first mea-
surement data will show
in the upper row of the
screen.
6. Aim ate the new tar-
get.
7. Press key again to
take a second measure-
ment.
8. The second length is
shown in the lowest row
of the screen, and the
laser beam switches off.
15
surement mode.
SINGLE-DISTANCE MEA-
SUREMENT
1. Press key to turn on
t h e tool, it will de-
fault to single-distance
measurement
2. Press key to turn on
the laser, the laser indica-
tor will blink. Aim the la-
key
E N G L I S H •
9. To take a new measurement, follow steps
5 through 8, above.NOTE: Ff after choosing
Area, Volume or Pythagorean Theorem measu-
rement modes, press
single-distance measurement mode.
AREA MEASUREMENT
1. Press
choose area measure-
ment mode; the blin-
king line in
indicates the length to
be measured.
2. Press key to turn
on the laser beam; the
laser indicator
blink.
3. Position the tool to aim the laser dot at the
target to which you want to measure.
4. Press key to dis-
play the measured
length in first row of
the screen the width
line in the
will start to blink.
5. Position the tool to
aim the laser dot at
the width target.
6. Press key again to
display the area in the lowest row of the
screen; the width will
be displayed at the
same time in the se-
cond row.
7. Press key to make
a new
measurement.
VOLUME
MEASUREMENT
1. Press key to choose volume measure-
ment mode. The blinking line in
cates the length to be
measured.
2. Press key to turn
on the laser beam; the
laser indicator
blink.
U ser's manual
key to switch back to
key to
"icon
will
cicon
icon indi-
will