Check Before Treatment - NSK Ti-Max Z45L Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

- Align the mark
and
to set the water spray shape.
- Align the mark
and
to set the water jet shape.
CAUTION
· Make sure to fully turn the Switching Valve.
· Before starting treatment, check the coolant water is flowing
normally.
· If water is not flowing normally, reset the Switching Valve again.

6. Check before treatment

Check that the Head Cap is firmly tightened. Also check for handpiece vibration, noise and overheating by rotating for about 1 minute. If any
abnormalities are found do not use the handpiece and contact your Authorized NSK Dealer.
Water spray
shape
Water jet shape
Switching Valve
Wrench
Fig. 3
7

Publicidad

Tabla de contenido
loading

Tabla de contenido