Maintenance - Truper SICI-7-1/4N3-2 Manual De Instrucciones

Keep in mind to disconnect the tool before cleaning or
servicing.
Every component in the tool is an important part of the
insulating system and should only be serviced in a
Authorized Service Center.
When sending the tool to a
zed Service Center, ALWAYS ask for original spare parts.
When cleaning the plastic parts of the tool, refrain from
using solvents. Most plastic materials are susceptible to
damage when commercial type solvents are applied.
Use a clean cloth or pressurized air to clean dirt, coal or
dust.
WARNING
NEVER expose the tool to oil, brake
fluid, petroleum based products, penetrating oils, etc.
They are made of chemical substances that may damage
or destroy plastics.
WARNING
When using pressurized air to blow off
particles ALWAYS wear protective glasses with side
protectors or a facemask. If too much dust is present use
a dust-mask.
It is not advisable to use this tool for prolonged jobs with
fiberglass, drywall or plaster. Their particles are highly
abrasive for any power tool components. When using a
tool in any of those materials, a very important measure is
to frequently clean with compressed air to increase the
useful life of the machine
.
Carbon brush replacement
• Carbon brushes should be checked periodically.
• When one or both carbon brushes show signs of wear go
to a
both carbon brushes replaced. When replaced, see if the
new carbon brushes move freely in the carbon brush
housing. Ask to turn on the tool during five minutes to
make the contact in the carbon brushes and the commuter
even.
• Use only original
brushes, designed specifically with the right strength and
electric resistance for each type of motor. Carbon brushes
with different specifications may damage the motor.
• When replacing carbon brushes, always change both.
10
ENGLISH
Authori-
Authorized Service center to have
spare carbon

Maintenance