Maintenance; Troubleshooting - Truper SCI-18 Manual De Instrucciones

Maintenance

Cleansing and Lubrication
• Turn OFF and disconnect the saw.
• Remove all the dust using a hard-brittle brush and a
vacuum cleaner. Pay attention to the mechanisms and the
motor air vents.
• Apply dry graphite lubricant or silicon in the mechanism.
ATENCIÓN
Do not use oil or grease because it
would accumulate saw dust and can hinder the function of
the mechanism.
• The motor bearings are factory sealed and lubricated. Do
not require additional lubrication.

Troubleshooting

Problem Cause
The machine is not • No power supply.
functioning when • The power cable is defective.
turned ON.
The band is not • The band tension knob is not tight.
moving when the
motor is running. • The band got loose from one of the flywheels.
• The saw band is broken.
• The direction band is broken.
The band is not • The longitudinal cutting guide is not being
cutting in a straight used.
line. • The feeding rhythm is too fast.
• The band teeth are dull or damaged.
• The band guides are not properly adjusted.
The band is not • The teeth are dull.
cutting, or it cuts too • The band is mounted backwards.
slowly.
Dust accumulates • This is due to normal use.
inside the machine.
Dust inside the • This is due to normal use.
motor cover.
The machine is not • The table is not set in the right angles with
cutting 45° or 90° regards to the band.
angles. • The band is dull or there was too much
pressure on the work piece.
The band cannot be • The flywheels are crooked.
set in the right
manner in the • The flywheel alignment knob has not been
flywheels. adjusted right.
• The band is defective.
Service
• Servicing the saw can only be carried out by
Authorized Service Center staff.
Service and maintenance carried out by non-qualified
personnel may be dangerous and could cause personal
injuries and makes Warranty void.
Solution
• Check and look for any tear in the cable.
• Go to a
Center to repair.
• Turn OFF the motor and tighten the band tension
knob.
• Open the cabinets and check the band setup.
• Replace the band.
• Replace the band.
• Use the longitudinal cutting guide.
• Feed the work piece slowly and using moderate
and constant pressure to prevent the band from
bending.
• Replace the band with a new one.
• Adjust the band guides (see page 11).
• Replace the band (see page 8).
• Set the band correctly.
• Clean the machine regularly. Open the cabinets and
remove dust with a vacuum cleaner and a brush.
• Clean the motor vents using a vacuum cleaner.
Remove dust constantly to prevent dust entering
inside the cover.
• Adjust the table (see page 10).
• Replace the band or exercise less pressure on the
work piece.
• Go to a
Center for repairs.
• Adjust the knob (see page 10).
• Replace with a new band.
Authorized Service
Authorized Service
ENGLISH 13