Tightening The Saw Chain - Dolmar PS-32 C Manual De Instrucciones

3 2
20
8
9
9 11
12
2
4
Lift the chain (9) over the sprocket (8).
CAUTION:
Do not insert the chain between the chain sprocket and
the disc.
Guide the chain from above about halfway into the groove
(10) on the guide bar.
10
CAUTION:
Note that the cutting edges along the top of the chain must
point in the direction of the arrow!
Pull the chain (9) around the sprocket nose (11) of the guide
bar in the direction of the arrow.
Replace the sprocket guard (3).
IMPORTANT:
Lift the saw chain over the chain catcher
(12).
Tighten the nuts (2) only hand-tight to begin with.

Tightening the saw chain

Turn the chain tensioning screw (4) to the right (clockwise)
until the saw chain catches in the groove on the lower side
of the guide bar (see circle).
Slightly lift the end of the guide bar and turn the chain adjusting
screw (4) to the right (clockwise) until the chain rests against
the bottom side of the guide bar.
While still holding up the tip of the guide bar, tighten the
retaining nuts (2) with the universal wrench.