GE JV247 Manual De Instrucciones página 14

14
SCREW IN PART WAY
Drive a mounting screw (from the hardware
packet) part way into each center of the
narrow neck of the keyhole slots marked on
the cabinet bottom.
15
OPTIONAL POWER CORD KIT JXHC1
An optional Power Cord Connection Kit, model
JXHC1, is available at extra cost from your
GE Appliances supplier for installation using a
standard 3-prong, grounded wall outlet. Follow
the Installation Instructions packed with the kit
to connect the power cord to the range hood.
C L
7
3 4
NOTE: If using optional Power Cord Kit
JXHC1, feed the power cord through the hole
in the top cabinet while raising the hood. Loop
any excess length of cord and tie away with a
suitable tape or tie.
16
FEED IN WIRES
Lift the hood into position and feed the house
wiring through the wiring knockout.
14
Installation Instructions
Cabinet
3-prong
wall outlet
(if using cord
connection)
1
1 4
1 dia. clearance hole
3 4
for optional power
supply location
17
SECURE HOOD
Slide the hood back against the wall. Tighten
the mounting screws. Be sure the screw heads
are in the narrow neck of the keyhole slot.
NOTE: DO NOT PUSH ON THE FAN BLADE.
Pushing on the blade may cause it to interfere
with other hood parts.
17
CONNECT DUCTWORK TO HOOD
(Ducted installations only)
with sheet metal screws through the holes in
the alignment ears.
Attachment ear tabs
Use duct tape to make joints secure and
airtight.
Duct tape
Mounting
screw (4)
Keyhole (4)
7 round duct
49-80589-7