Service Air Filter; Air Filter Assembly (Cartridge With Pre-Cleaner) - Briggs & Stratton 2691670 Manual Del Operador

11
7. Carefully remove the cap (B) and lower hose into an
approved container (C).
8. After the oil has drained, install the cap tightly, then attach
the hose to the side of the engine.
9. Remove the oil filter (B, Figure 12) and discard.
16
12
10. Lightly lubricate the oil filter gasket (A) with clean oil.
11. Install the oil filter by hand until the gasket touches the oil
filter adapter (C) then tighten the oil filter 1/2 to 3/4 turns.
12. Add oil. See the Check and Add Engine Oil section.

Service Air Filter

Refer to the Engine Manual.

Air Filter Assembly (Cartridge with pre-cleaner)

WARNING
DO NOT start or run the engine with the air cleaner
assembly or air filter removed as it is a fire hazard.
NOTICE
Do not use pressurized air or solvents to clean the filter.
Pressurized air can damage the filter, and solvents will
dissolve the filter.
1. Loosen the fasteners (A, Figure 13) and remove the
cover (B).