Mower Blade Stop Time; Change The Engine Oil - Briggs & Stratton 2691670 Manual Del Operador

2. First disconnect the negative (-) battery cable (A,
Figure 9) from the battery. Then, disconnect the positive
(+) battery cable from the battery.
3. Remove the battery hold-down strap (B) and the battery.
4. Clean the battery compartment with a solution of baking
soda and water.
5. Clean the battery terminals and cable ends with a wire
brush and battery terminal cleaner.
6. Install the battery with the battery hold-down strap (B).
7. First connect the positive (+) battery cable to the battery.
Then, connect the negative (-) battery cable (A, Figure 9)
to the battery.
8. Apply a layer of petroleum jelly or non-conducting grease
to the cable ends and the battery terminals.

Mower Blade Stop Time

WARNING
If the mower blade does not come to a complete stop within
5 seconds, the clutch must be adjusted. Do not operate the
machine until the correct adjustment has been performed by
a Briggs & Stratton Authorized Service Dealer.
The mower blades and mower drive belt must stop within
five seconds after the electric Power Take-Off (PTO) switch
turns OFF. If the mower drive belt does not stop within five
seconds, see a Briggs & Stratton Authorized Service Dealer
for repairs.

Change the Engine Oil

1. Run the engine until warm.
2. Put the tractor on a level surface (Figure, 10).
10
3. Stop the engine and remove starter insert (A, Figure 1).
4. Clean the oil fill and filter areas of any debris.
5. Remove dipstick (B) and lay on clean cloth.
6. Disconnect the oil drain hose (A, Figure 11).
15