Remote Control - 3M X64 Guía De Seguridad Del Producto

Putting batteries
Please load the batteries before using the remote control. If the remote control starts to malfunction, replace
the batteries. If you will not use the remote control for an extended period, remove the batteries from the
remote control and store them in a safe place.
1. Slide back and remove the battery cover in the
direction of the arrow.
2. Align and insert the two AA batteries according to
their plus and minus terminals as indicated in the

remote control.

3. Replace the battery cover in the direction of the
arrow and snap it back into place.
• Always handle the batteries with care and use them only as directed. Improper use
and/or pollution of the surrounding environment.:
-
at the same time. Do not mix a new battery with used one.
- Make sure the plus and minus terminals are correctly aligned when loading a battery.
- Keep a battery away from children and pets.
- Do not recharge, short circuit, solder or disassemble a battery.
-
- If you observe battery leakage, wipe out the battery residue and replace the battery.
If the residue adheres to your body or clothes, rinse well with water immediately.
- Obey the local laws on disposing the battery.
© 3M 2007
Remote control
WARNING
3M™ Multimedia Projector X64 Product Safety Guide 13