Camera Installation; Installation Warnings; Camera Stand Installation - Lorex L200 Serie Manual De Instrucciones

Camera Installation

Before you install the camera*, carefully plan where and how it will be positioned, and where you will
route the cable that connects the camera to the system.

Installation Warnings:

•
Select a location for the camera that provides a clear view of the area you want to monitor, which
is free from dust, and is not in line-of-sight to a strong light source or direct sunlight.
•
Plan the cables' route so that it is not close to power or telephone lines, transformers, microwave
ovens or other electrical equipment that could interfere with the DVR.
•
Select a location for the camera that has an ambient temperature between 14°F~113°F
(-10°C~45°C)
•
If you plan to install the camera in a location that has conditions not recommended in this manual,
consult with a professional installer and consider use of a separate camera cover or housing
•
Before starting permanent installation, have another person hold the camera for you while you
verify its performance by observing the image on a monitor.

Camera Stand Installation:

1. Attach the pedestal to the ceiling, wall or other surface by
the base using the provided screws.
2. The mounting bracket must be attached to a structural
device such as a wall stud or ceiling rafter using the supplied
screws.
3. Attach the camera to the pedestal. Adjust the angle of the
camera, and tighten the thumbscrew to set the position
NOTE: The camera can be attached to the stand
using the screw point on the top or the bottom (to
maintain proper camera alignment). This prevents
the image from becoming inverted.
* Camera may not be exactly as shown
Camera Installation
Wall Mount
Ceiling Mount
15