Appendix C: Replacing The Hard Drive; Sata Hard Drive; Replacing The Hard Drive - Lorex L200 Serie Manual De Instrucciones

Appendix C: Replacing the Hard Drive

Appendix C: Replacing the Hard Drive

SATA Hard Drive

(L218/L214)
The system comes with a pre-installed SATA hard drive; however the unit will work with a replacement
single SATA hard drive (up to 1 TB).
The hard drive storage capacity and model name are shown on the loading screen when the system loads.
If the system does not recognize the hard drive, the system will not boot. If a new hard drive is connected,
the system will prompt you to format the drive. Any drive formatted by the system will not be recognized
by a PC, and the data cannot be accessed.
NOTE: Make sure that the DVR is OFF and the power cable has been disconnected before changing the
hard drive.

Replacing the Hard Drive

To replace the hard drive:
1. Remove the four screws on the side panels and one screw on the rear panel. Carefully remove the
metal casing.
2. Disconnect the power and data cables from the hard drive.
3. With one hand supporting the hard drive, remove the four screws beneath the housing holding the hard
drive in place. Keep the four rubber feet for the new drive.
4. Place the new drive in the housing and replace the rubber feet and four screws. Make sure the
connector pins are facing toward the cables.
5. Reconnect the power and data cables.
6. Replace the metal casing and secure with the four screws on the side panels and one screw on the rear
panel.
64