RIB JOLLY 20 Manual De Instrucciones página 23

CONNECTION DRAW OF: JOLLY + PUSH-BUTTON + KEY SELECTOR
B = Electrobrake
G = Earth
If JOLLY is required complete with electrobrake, the connection of the electrobrake to the
motor is made in factory.
To connect JOLLY to J-CRX, code ABJ7080 (230/50-60Hz) or code ABJ7079 (120/60Hz),
consult the control board instructions.
In the draw you can see how connect the push button for the opening and closing control on
the inside of the premises and of the key selector for the external control.
CONNECTION DRAW OF: 2 JOLLY + PUSH-BUTTON + KEY SELECTOR
B = Electrobrake
G = Earth
LN = Line 1-Phase
M = Motor
LN = Line 1-Phase
M = Motor
KEY-SELECTOR
green / yellow
G N L
U
= Common
V/W = Inverters
IMPORTANT: Use proper push button and key selector.
TRANSMITTER AND PHOTOCELLS:
- RIB can supply electronic control board for the remote control through transmitter, push
button, key selector;
- The control board can also be arranged or the connection of safety photocell.
KEY-SELECTOR
green / yellow
G N L
U = Common
V/W = Inverters
23
close
PUSH-BUTTON
open
8
close
PUSH-BUTTON
open
9
G
B