Safety Agency Compliance Statements; Safety Precautions; Modifications To Equipment - Sun Microsystems SPARC Enterprise T2000 Manual De Instrucciones Y Guía De Seguridad

Safety Agency Compliance
Statements
Read this section before beginning any procedure. The
following text provides safety precautions to follow when
installing a Sun Microsystems product.

Safety Precautions

For your protection, observe the following safety
precautions when setting up your equipment:
Follow all cautions and instructions marked on the
■
equipment.
Ensure that the voltage and frequency of your power
■
source match the voltage and frequency inscribed on
the equipment's electrical rating label.
Never push objects of any kind through openings in
■
the equipment. Dangerous voltages may be present.
Conductive foreign objects could produce a short
circuit that could cause fire, electric shock, or damage
to your equipment.
Symbols
The following symbols may appear in this book:
Caution – There is a risk of personal injury
and equipment damage. Follow the
instructions.
Caution – Hot surface. Avoid contact.
Surfaces are hot and may cause personal
injury if touched.
Caution – Hazardous voltages are present. To
reduce the risk of electric shock and danger to
personal health, follow the instructions.
Depending on the type of power switch your device has,
one of the following symbols may be used:
On – Applies AC power to the system.
Off – Removes AC power from the system.
Standby – The On/Standby switch is in the
standby position.

Modifications to Equipment

Do not make mechanical or electrical modifications to the
equipment. Sun Microsystems is not responsible for
regulatory compliance of a modified Sun product.
Placement of a Sun Product
Caution – Do not block or cover the openings
of your Sun product. Never place a Sun
product near a radiator or heat register.
Failure to follow these guidelines can cause
overheating and affect the reliability of your
Sun product.
Noise Level
Product: Sun SPARC Enterprise T2000
Declared Noise emissions in accordance with ISO 9296.
LWAd (1B=10dB)
LpAm (bystander positions)
SELV Compliance
Safety status of I/O connections comply to SELV
requirements.
Operating Idling
7.7 B 7.7 B
62 dBA 62 dBA
5