Installation And Initial Operation; Connecting The Battery - VOSS.farming Sunny 800 Instrucciones De Operación

7

INSTALLATION AND INITIAL OPERATION

WARNING
There is a risk of smouldering in the event of heat accumulation. The unit must
not be covered with textiles etc. during operation, as this may cause heat to build
up and possibly cause a fire. Therefore, do not install the unit in areas at risk of
fire (e.g. hay and straw storage areas).
NOTICE
Never cover the device to avoid damaging the device and the solar module.
7.1

CONNECTING THE BATTERY

Info
When delivered, the battery is not connected to the energiser.
WARNING AGAINST ELECTRICAL VOLTAGES
Make sure that the energiser is switched off before connecting the battery.
1. Loosen the Allen screw (7) on the bottom of the energiser and put the energiser
back down.
You can now open the energiser and access the battery (12V 7.2Ah).
2. Connect the red and black wires to the battery.
3. Close the energiser and tighten the Allen screw (7) again.
The energiser is ready for operation.
7.2 INSTALLATION
WARNING AGAINST ELECTRICAL VOLTAGES
Do not lay PVC cables at a temperature below +5°C.
NOTICE
Ensure that the energiser is placed securely during installation. The energiser
must be operated upright with the cover closed.
1. Select a location, taking into account the general safety instructions, that meet the
following criteria:
next to the electric fence and preferably near the centre of the electric fence
ƒ
where the highest solar radiation in the season is reached
ƒ
where a good grounding can be achieved
ƒ
on solid ground away from possible flooding and out of reach of animals and
ƒ
children (inside a protective fence if necessary)
2. Mount the unit in a suitable location. You can use the supplied mounting post for
this purpose.
WARNING
Fire hazard. Only install the unit on a fireproof surface.
32
INSTRUCTION MANUAL VOSS.FARMING SUNNY 800
42088 | 01 | 2021 | V3