Coolant Level Check - Husqvarna SMR 511 2012 Manual De Uso

COOLANT LEVEL CHECK

Check level (1) inside left radiator, with the engine cold
and the vehicle in vertical position. The coolant should
be approximately 10 mm (0.4 in) above the cells.
1
The radiator cap (2) features two locking positions, the
first being for the previous pressure discharge of the
cooling system.
CAUTION*:
Avoid removing radiator cap (2) when
engine is hot, as coolant may spout
out and cause scalding.
2
Note *:
Difficulties may arise in eliminating coolant from painted
surfaces. If this occurs, wash off with water.
SPECIFICATIONS - OPERATION - MAINTENANCE
COOLANT REPLACEMENT
WARNING*: Coolant shall be replaced
with cold engine and coolant.
- Place a container on cylinder right side, under coolant
drainage screw (1). FIRST remove the screw (1) then
SLOWLY open the L.H. radiator cap (2); slope the mo-
torcycle on the right side to drain the coolant easily in
the vessel. Reassemble the screw (1).
1
2
EN - 23