Coolant Level Check - Husqvarna SMR 450-R 2009 Manual De Uso Y Mantenimiento

COOLANT LEVEL CHECK

Check level (1) in right-hand radiator when engine is cold
(place the motorcycle so that it is perpendicular to the ground).
The coolant should be approximately 10 mm above cells.
The radiator cap is provided of two unlocking positions, the
first being for the previous pressure discharge in the cooling
system.
1
WARNING
Avoid removing radiator cap when engine is
hot, as coolant may spout out and cause
scalding.
NOTE
Difficulties may arise in eliminating coolant
from varnished surfaces. If this occurs, wash
off with water.
REPLACEMENT OF COOLING FLUID
Place a vessel on the R.H. side of the cylinder, under the
coolant drain screw (1).
FIRST remove the screw (1) then SLOWLY open the R.H. radia-
tor cap (2); slope the motorcycle on the right side to drain the
coolant easily in the vessel. Reassemble the screw (1).
Pour the necessary quantity of coolant in the radiator then warm
up the engine in order to eliminate any possible air bubble.
1
2
21