Pairing Of Transmitters, Selecting The Transmitters - VDO MC 2.0 WL Manual De Instalación Y Operación

DE ENG FR IT ES

3.8 Pairing of transmitters, selecting the transmitters

The speed, heart rate and cadence signals are transmitted to your
computer in digital, encoded format. This technology is less prone to
interference than analogue transmission, thus preventing data over-
laps (cross talk) when cycling in a group. For the computer to acquire
the digital encodings from the transmitter, pairing must occur:
Step 1 Select whether you want to view the heart rate or cadence or
no heart rate/cadence data on the display.
Press and hold
Press ALTI A
CADEnCE or HEArTrATE or nOnE (no heart rate and
no cadence). Confirm your selection by pressing
HEArTrATE--SELECT OK? or CADEnCE--SELECT OK?
or nOnE--SELECT OK? appears on the display.
Confirm the selection by pressing
The MC 2.0 confirms by displaying SEnSOr
SELECT--DOnE.
52 MC 2.0 WL
NL PL
M + for three seconds.
or P to select the desired transmitter
M .
VDO CYCLECOMPUTING
Step 2 Place the computer into the handlebar bracket. The speed
and Hr or cadence displays now flash. If you have not selected a
transmitter (heart rate or cadence), only the speed display flashes.
The flashing indicates that the computer is searching for its
transmitter.
Step 3 now spin the front wheel or simply set off and the computer
acquires the digital encodings (pairing). If the pairing process was
successful, the speed and heart rate or cadence will appear on the
display.
ATTENTION: the time window for pairing is five minutes.
M . If you do not start cycling during these five minutes, no pairing
takes place. The speed, heart rate or cadence will not be displayed.
The pairing then has to be repeated:
If the computer has gone into sleep mode, a new pairing process
B
is started by pressing a button.
Alternatively:
Place the computer back into the handlebar bracket.