End Of Operation - Taski swingo 4000 Manual De Instrucciones

Cleaning method
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in sev-
eral work steps.
Notice:
More precise details regarding the direct
and indirect working method can be found
on the respective method sheet.
Please contact your TASKI customer con-
sultant for further details.
Notice:
The machine guiding might be impaired in
case of special combinations of flooring/
contamination and cleaning product.
Optionally available wheels can improve
the traction of the machine on the floor.
Please contact your TASKI customer con-
sultant.
Replenishing cleaning solvent
Attention:
The flooring may be damaged when work-
ing without cleaning solution.
Notice:
A rattling noise from the pump indicates an
empty fresh water tank (Flextank).
Attention:
The pump must never run dry for an ex-
tended period.
• The fresh water tank display lights
up.
Fresh water tank is empty.
• The machine must be switched off.
• Open the tank lid.
• Fill water into the fresh water tank (Flextank), see page 90.
• Add the cleaning product using the dosing cup.
• Tilt the tank cover back to the original position.
Empty recovery tank
• The recovery tank display lights up.
Recovery tank is full.
• Drain the recovery tank, see page 94.

End of operation

Manual process
• Press the Brush drive ON/OFF but-
ton.
• Continue to drive a few meters.
• Press the Brush drive ON/OFF but-
ton.
The display lights up and the brush
unit is stopped and lifted.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Press the Suction unit ON/OFF but-
ton.
The display lights up and the squee
gee is automatically lifted.
The suction engine continues run
ning for 15 seconds to prevent drip
ping.
Automatic process
• Press the Program ON/OFF button.
The cleaning solution supply is
stopped.
The brush unit is stopped and lifted.
After 30 seconds, the squeegee is
lifted.
The suction motor is still on for 15
seconds until it is automatically
switched off.
Removing and cleaning the squeegee
• The machine must be switched off.
• Remove both suction hoses from the connectors and con-
nect them to the hose holder.
• Compress the position locks. The
squeegee is released and can be re-
moved from the squeegee holder.
• Clean the squeegee under running water using a brush.
• After thorough cleaning, hang the squeegee on the squee-
gee suspension on the rear of the machine.
Notice:
Only cleaned and intact blades ensure op-
timal suction results!
EN
-
-
-
93