Taski swingo 350B Manual De Instrucciones página 73

Battery capacity - end of operational readiness
• The battery level indicator notifies
you that the machine is ready for op-
eration.
• Blinking red LED:
2 minutes to finish working before the machine automati
cally switches off.
• Solid red LED:
Requires a full charging cycle.
Cleaning method
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in sev-
eral work steps.
Notice:
More precise details regarding the direct
and indirect working method can be found
on the respective method sheet.
Please contact your TASKI customer con-
sultant for further details.
Notice:
The machine guiding might be impaired in
case of special combinations of flooring/
contamination and cleaning product.
Replenishing cleaning solvent
Attention:
The flooring may be damaged when work-
ing without cleaning solution.
• The machine must be switched off.
• Open the tank lid.
• Fill the fresh water tank with water, see page 69.
• Add the cleaning product using the dosing cup.
• Close the tank lid.
Empty recovery tank
Recovery tank full:
• If the recovery tank is full, the floater
will be sucked onto the suction filter.
This will be indicated by a change of
the noise by increasing the suction
speed as well as residual water at the
bottom.
• Drain the recovery tank, see page 72.
Stairs
Notice:
The machine must only be transported
over stairs by two persons.
• The machine must be switched off (main switch) and the
battery disconnection plug must be disconnected.
Attention:
Lifting the machine can be dangerous un-
der any circumstances!
Stumbling may cause personal injuries or
machine damage.
Attention:
Both the fresh water and the recovery tank
-
must be emptied completely before lifting
the machine.
• To lift, grip the machine at the re-
cessed grip by the squeegee while
the second person holds the ma-
chine handle.
EN
71