GE Monogram ZDT800 Serie Manual De Instrucciones página 10

Using the Dishwasher
Dishwasher
Lighting
Features
Water
Temperc]ture
Interior Lights
The interior LEDlights provide better visibility for
loading and unloading. Do not look directly into
the LED lights. They turn on when the door is
opened and turn off when the door is closed.
The lights will turn off after 15 minutes if the door
remains open. To turn the lights back on, close
and open the door.
Do not attempt to replace the bulbs. If light bulb
replacement is necessary, please contact the
GE Answer Center for service by calling
1.800.626.2000.
The entering water must be at least 120°F (49°C)
and not more than 150°F (66°C),for effective
cleaning and to prevent dish damage.
Check the water temperature with a candy or
meat thermometer. Turn on the hot water faucet
nearest the dishwasher, place the thermometer
in a glass and let the water run continuously into
the glass until the temperature stops rising.
Recommended
Dishwasher
Products
GErecommends the following products for use in
its dishwashers:
. Foryour manual detergent dispenser, Cascade@
Platinum Pacs are recommended. Powders,
liquids, and gels may also be used but may not
work as effectively.
. For your rinse agent dispenser, Cascade@
Complete Rinse Aid.
Use o Rinse
Agent
10
Rinseagents, such as Cascade® Complete Rinse
Aid are designed for great drying action and to
protect against spots and film build-up on your
dishes, glasses,flatware, cookware, and plastic.
Filling the Dispenser
The rinse agent dispenser holds 3.5 oz. (104 ml) of
rinse agent. Under normal conditions, this will last
approximately one month.
r_ Makesurethe dishwasherdoor isfully open.
r_ open the Rinse Agentdispenser d oor.
r_ Slowlyadd rinseagent untilthe cup isfull.Youmay
needto pauseseveral t imesto allow rinseaid to
settle.
_-...
lndicctor
,indow
E] Cleanup anyspilledrinseagentwith a damp clothto
preventfoam from forming insidethe dishwasher.
r_ Close the Rinse Agentdispenser d oor.
Rinse Aid Setting
The amount of rinse agent released into the final
wash can be adjusted. If water drops or hard water
spots remain on dishes after the dry cycle, increase
the setting.
To adjust the setting
Open the Rinse Agentdispenser door; then turn
the adjuster clockwise to increase the amount of
rinse agent, counterclockwiseto reducethe amount
of rinse agent.
Clockwise to reduce Counterclockwise
water drops and to reduce foaming
hard water spots