Care And Cleaning - GE Monogram ZDT800 Serie Manual De Instrucciones

Cleaning
the Exterior
Door Panel
Cleaning
the Control
Panel
Cleaning
the
Interior
Care and Cleaning
Dishwasher
Before cleaning the front panel, make sure you
know what type of panel you have. Refer to the last
two letters of your model number. You can locate
your model number on the left-hand tub wall just
inside the door. If your model number ends with
SS,then you have a Stainless Steel door panel. If
your model number ends with II, then you have an
Integrated door panel.
Follow the instructions below for cleaning the door
panel for your specific model.
Stainless Steel Door Panel (model numbers ending
in SS)
The stainless steel panels can be cleaned with
Stainless Steel Magic or a similar product using a
clean, soft cloth. Do not use appliance wax, polish,
bleach or products containing chlorine on Stainless
Steel doors.
Do not use scouring pads or powder cleaners
because these products can scratch the finish.
You can order Stainless Steel Magic #W×lOX29
through GE Parts by calling 1.877.959.8688 or
visiting GEApplianceparts.com In Canada, call
1-800-661-1616.
Integrated Door Panel (model numbers ending in II)
This is a custom installed door panel, and you
will need to refer to the cabinet manufacturers
recommendations for proper cleaning.
To clean the control panel, use a lightly dampened
cloth. Then dry thoroughly.
To clean and de-odorize your dishwasher, use citric
acid or Lemi Shine@*, a detergent additive. Lemi
Shine will break up mineral deposits, and remove
hard water film and stains. You can order citric acid
#WD35×151 through GE Parts by calling 877-959-
8688 or visiting GEApplianceparts.com. In Canada,
call 1-800-661-1616. You can purchase Lemi Shine
at your local grocery store or by calling GE at the
numbers above and ask for W×10×10019.
Stainless
Steel Inner
Door and
Tub
The stainless steel used to make the dishwasher
tub and inner door provides the highest reliability
available in a GE dishwasher.
If the dishwasher tub or inner door should be
scratched or dented during normal use, they will
not rust or corrode. These surface blemishes will
not affect their function or durability.
* Lemi Shine@ is a registered trademark of Envirocon Technologies, Inc. 2 "J