Maintenance Activities - Holmatro CC 23 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 71
Object
Pinching arms
Snap ring of hinge pin
Centre bolt
Hinge pins
Carrying handle
Deadman's handle
Light
8.4

Maintenance activities

8.4.1
General
After every use:
1. Check the operation of the tool.
2. Check the tool for damage and leaks. If the tool does not work properly and/or leaks, have it
repaired by a Holmatro Certified Technician.
8.4.2
Hydraulic couplers
Check the couplers for damage. Have a Holmatro Certified Technician replace damaged couplers.
Clean the coupler with luke warm water and a mild soap solution.
Dry the couplers.
Lubricate the end of the coupler with hydraulic oil or inject WD-40.
Lubricate the locking ring by injecting WD-40 into the space between the back section and the
locking ring.
Connect the couplers and check whether the coupler locks automatically. Check the locking by
pulling the hoses apart with a normal manual effort. The couplers must not slip.
Disconnect the couplers by turning the locking ring and pulling it backwards.
Connect and disconnect the couplers a few times to improve the internal lubrication of the locking
system.
8.4.3
Dust caps
Check the dust caps for damage. Replace damaged dust caps.
Clean the dust caps with running water. Dry the dust cap and treat it with preservative oil.
8.4.4
Hydraulic hoses
Clean the hose with luke warm water and a mild soap solution.
CC 23
Action
Check
Check
Check
Check
Check
Check
Check
916.001.550_003
Time interval
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
EN
35

Publicidad

Tabla de contenido
loading

Tabla de contenido