Operating The Light Switch; Hose With Core™ Couplers - Holmatro CC 23 Manual De Instrucciones

EN
/i
Hold the deadman's handle in this position to move the plunger(s) out of the cylinder.
Pressure is built up in the tool. Return oil from the tool flows back to the pump
without pressure.
Hold the deadman's handle in this position to move the plunger(s) back into the
cylinder. Pressure is built up in the tool. Return oil from the tool flows back to the
pump without pressure.
The tool has a return line safety valve. If the return line to the pump is blocked, this overpressure return
line safety valve will prevent excessive pressure in the tool by allowing oil to leak out.
CAUTION
Never change the setting of the return line safety valve.
5.5

Operating the light switch

On the carrying handle there is a light switch for the integrated LED lights.
• Press the light switch to turn the LED lights on and off.
• The battery for LED lights should be replaced when the LED lights no longer turn on when the light
switch is pressed.
5.6 Relief the pressure in unconnected hoses and tools
5.6.1 General
Temperature differences can cause overpressure in unconnected hoses and tools. This overpressure
can make it impossible to connect the parts. You can use the pressure relief tool to remove this
overpressure. This accessory is available for all Holmatro hose systems and is supplied by default with
every pump.
NOTICE
We recommend you keep more than one of these tools on hand.
5.6.2 Hose with CORE™ couplers
Refer to Fig. 6.
• Hook the pressure relief tool over the male coupler (1).
• Turn the knob clockwise (2) to release the pressure. Some oil will be released.
• Turn the knob counterclockwise (3).
• Remove the pressure relief tool from the coupler (4).
30 916.001.550_003 CC 23