Holmatro CC 23 Manual De Instrucciones página 36

EN
• Check the hose for damage and leaks. Replace the hose if it leaks, has kinks, the reinforced cover
is visible or it has blisters or bulges higher than 1 mm. In case of doubt always contact the Holmatro
dealer who can assess the seriousness of the damage.
• Replace the hose no later than 10 years after the date of manufacture, regardless of its use and
external appearance. The date of manufacture is part of the test code, the first 4 digits of the test
code specify the date of manufacture of the hose (yymm*****).
8.4.5 Accessories
• Check the accessories for damage, dirt and completeness. Replace damaged accessories and
make sure that the accessories are complete.
• Remove dirt with clean running water. Dry the accessories. Apply a thin coat of preservative oil to
the external steel parts.
8.4.6 Deadman's handle
• Check whether the deadman's handle returns to the neutral position.
• Check the operation of the deadman's handle. Have the Holmatro dealer repair the deadman's
handle if it does not function properly.
8.4.7 Carrying handle
• Check the carrying handle for damage. Replace a damaged carrying handle.
• Check the attachment of the carrying handle. If necessary, fasten it firmly by tightening the bolts.
8.4.8 Centre bolt
Refer to Fig. 9.
Grease through the nipple with Molykote BR2 grease.
WARNING
Do not remove the centre bolt.
8.4.9 Snap rings of hinge pins
See Fig. 10.
• Check that the snap rings of the hinge pins (A) are present and are not damaged.
Have a Holmatro Certified Technician mount a new snap ring if it is missing or damaged.
8.4.10 Hinge pins
See Fig. 10.
• Spray Teflon lubricating oil on and between the moving parts of the hinge pins (A) while the tool is
opening and closing.
WARNING
The hinge pins may not be removed.
8.4.11 Light
• Check the light.
• Replace the battery if it gives little or no light.
• Have a Holmatro Certified Technician repair the light if a new battery does not solve the problem.
36 916.001.550_003 CC 23