VALPES VR Manual De Instalación Y Funcionamiento página 37

FAILSAFE: electric diagram

The terminal temperature can reach 90°C

The used wires must be rigid (feedback voltages: 4 to 250V AC/DC)

The two functioning modes « pre-set to closed » and « pre-set to open » are two different products (pre-set
in factory) and can't be interchangeable.
E- : black wire
F+ : red wire
LOAD STATE
FEEDBACK
ACTUATOR WIRING
SUGGESTED CUSTOMER WIRING
DSBA3400 • Rév. 24/01/2019
BATTERY BLOCK
Failsafe security unit
F+
E-
65
Loaded battery : closed
contact
66
Control and power supply card
17 17
100V-240V 50/60Hz (100V-350V DC)
15V-30V 50/60Hz (24V-48V DC)
18 18
1 2 3
Open
N Ph
GS2
Pre-set to closed
On-Off mode
ENGLISH
UK
D1
D2
1 2 3
Close
N Ph
GS2.O
Pre-set to open
37