GALAGAR GAR AC 180 Manual Técnico De Instrucciones página 18

CHAPTER 6. SAFETY MEASURES.
The use of this equipment requires a maximum amount of responsibility with respect to their use and
maintenance. Read this safety chapter carefully as well as the rest of the instructions manual. The correct use
of the equipment will depend on this.
• Make sure that the part to be welded makes perfect electrical contact with the equipment ground.
• During any maintenance operations or when dismantling any element from the inside of the machine, this
must be disconnected from the electricity supply.
• Do not touch the equipment switches when carrying out a welding operation.
• Never lean directly on the work part. We will always work with protection gloves.
• Any work on the welding guns and ground will be done with the equipment disconnected (OFF Position (0)
on the on/off switch). Do not touch the electrically active parts (electrode-holder clip, ground, etc.) with your
bare hand.
GAR AC/DC 180. Instructions Manual.
For your safety and that of others, remember that:
ANY PRECAUTION MAY BE INSUFFICIENT!
The welding equipment referred to in this manual are electrical.
important therefore to observe the following safety measures.
• Any work on the equipment must only be carried out by specialists.
• The equipment must be connected to the earth connection and this must always
be effective.
• The equipment must not be located in a damp place.
• Do not use the equipment if the welding or supply cables are damaged. Use
original spares.
The part to be worked on should be cleaned from possible grease or
solvents as these may decompose during the welding process giving off fumes which
could be very toxic. This can also occur with those materials which have some kind
of surface coating (zinc-plated, galvanised, etc.). Avoid inhaling the fumes given off
in the process at all times. Protect yourself from the fumes and metal dust which can
be given off. Use quality approved anti-fume goggles. Work with this equipment
must be carried out in places or working posts where there is suitable air renewal. If
welding processes are carried out in closed places the use of suitable fume extractors
is recommended.
In welding processes, the electric arc formed gives off infrared and ultraviolet
type irradiations: these are harmful for the eyes and skin, so these areas must be
suitably protected with gloves and suitable clothing. The eyes must be protected with
goggles with an quality approved protection system with a protection index of at least
11. With electric arc welding machines use protection shield for the eyes and face.
With electric cutting machine use protection goggles. Always use quality approved
protection elements. Never use contact lenses. They may adhere to the cornea due
to the great heat given off during the process. Bear in mind that the arc is considered
to be dangerous within a 15 metre radius.
Cast material projections are given off during the welding process so due
precautions must be taken. There must be a fire-extinguisher near to the working area.
Do not keep inflammable material or explosives near to the working post. Prevent fire
caused by sparks or slag. Use quality approved footwear for this type of operations.
Never direct the path of a the electrode-holder clip towards people.
18
It is