EGO POWER+ HTA2000 Manual De Instrucciones página 363

◾
Carry the pole saw with two hands on the handles,
with the pole saw switched off. When transporting
or storing the pole saw always fit the guide bar
cover. Proper handling of the pole saw will reduce the
likelihood of accidental contact with the moving saw
chain.
◾
Do not remove cut material or hold material to be
cut when blades are moving. Make sure the switch
is off when clearing jammed material. Saw chain
continues to move after the switch is turned off. A
moment of inattention while operating the pole pruner
may result in serious personal injury.
◾
Follow instructions for lubricating, chain
tensioning and changing accessories. Improperly
tensioned or lubricated chain may either break or
increase the chance for kickback. Keep cutting edge
sharp and clean for best performance and to reduce
the risk of injury.
◾
Keep handles dry, clean, and free from oil and
grease. Greasy, oily handles are slippery causing loss
of control.
◾
Cut wood only. Do not use pole saw for purposes
not intended. For example: do not use pole saw
for cutting plastic, masonry or non-wood building
materials. Use of the pole saw for operations different
than intended could result in a hazardous situation.
◾
Do not use the pole saw in bad weather conditions,
especially when there is a risk of lightning. This
decreases the risk of being struck by lightning.
◾
Stop the motor and remove the battery pack
whenever you leave the tool.
◾
Store Idle Appliances Indoors. When not in use,
appliances should be stored indoors in a dry and high
or locked-up place with the battery pack removed, out
of reach of children.
◾
Check Damaged Parts. Before further use of the
product, a guard or other part that is damaged should
be carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other condition
that may affect its operation. A guard or other part that
is damaged should be properly repaired or replaced
by an authorized service center unless indicated
elsewhere in this manual.
ADDITIONAL WARNINGS
◾
Do not charge the battery pack in rain, or in wet
locations.
◾
Use only with EGO's battery packs and chargers.
BATTERY PACK
BA1120E, BA2240E, BA2800
BA3360, BA4200
◾
The battery pack must be removed from the
appliance before it is scrapped.
◾
The battery shall be disposed of safely.
◾
Do not dispose of the battery in a fire. The cells may
explode. Check with local codes for possible special
disposal instructions.
◾
Do not open or mutilate the battery. Released
electrolyte is corrosive and may cause damage to the
eyes or skin. It may be toxic if swallowed.
CAUTION!
The electrolyte is a dilute sulfuric acid that
is harmful to the skin and eyes. It is electrically conductive
and corrosive.
◾
Exercise care in handling batteries in order not
to short the battery with conducting materials
such as rings, bracelets, and keys. The battery or
conductor may overheat and cause burns.
◾
Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in
operating condition. Be aware of possible hazards
even when the tool is not operating. Take care when
performing maintenance or service.
◾
Remove the battery pack before servicing, cleaning
or removing material from the tool.
◾
Replacement Parts - When servicing, use only
identical EGO replacement parts. Use of any other
accessory or attachment may increase the risk of
injury.
◾
Do not wash with a hose; avoid getting water in
motor and electrical connections.
◾
If situations occur that are not covered in this
manual, use care and good judgment. Contact the
EGO Service Center for assistance.
◾
Save these instructions. Refer to them frequently
and use them to instruct others who may use this tool.
If you lend this tool to someone else, also lend these
instructions to them to prevent misuse of the product
and possible injury.
SAVE THESE INSTRUCTIONS
NOTE: SEE YOUR POWER HEAD OPERATOR'S
MANUAL FOR ADDITIONAL SPECIFIC SAFETY RULES.
POLE SAW ATTACHMENT — PSA1000
EN
CHARGER
CH2100E
CH5500E
7