Packing List - EGO POWER+ HTA2000 Manual De Instrucciones

◾
The declared vibration total value may also be used in
EN
a preliminary assessment of exposure.
NOTICE:
The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used; In order to protect the operator, user should
wear gloves and ear protectors in the actual conditions
of use.

PACKING LIST

PART NAME
Hedge Trimmer Attachment
Wrench
Blade Scabbard
Operator's Manual
DESCRIPTION
KNOW YOUR HEDGE TRIMMER ATTACHMENT (Fig. A)
1. Cutting Blade
2. Quadrant
3. Trigger
4. Hedge Trimmer Shaft
5. Soft Sleeve
6. End Cap
7. Adjusting Lever
8. Gear Case
9. Wrench
10. Blade Scabbard
11. Tip Protector (Optional, SOLD SEPARATELY)
ASSEMBLY
WARNING:
If any parts are damaged or missing,
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product
or create accessories not recommended for use with this
hedge trimmer. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possibly serious personal injury.
WARNING:
Never attach or adjust any attachment
while the power head is running or with the battery
installed. Failure to stop the motor and remove the battery
may cause serious personal injury.
8
HEDGE TRIMMER ATTACHMENT — HTA2000
ADJUSTING THE CUTTING BLADE
When the hedge trimmer is removed from the package,
it is folded in its storage position where the cutting blade
is against the shaft (Fig. B). It is recommended to adjust
the cutting blade to a suitable working position before
attaching it to the power head.
There are 12 possible working positions. The angle of the
cutting blade can be adjusted upwards in 4 stages from
0° (straight) to 45°, and downwards in 7 stages from 0°
to 90° (right angle facing down) (Fig. C).
1. Press the trigger on the adjusting lever and
QUANTITY
meanwhile rotate the adjusting lever to adjust the
1
cutting blade to the desired cutting position (Fig. D).
1
2. Once the desired position has been reached, release
the trigger. An audible click indicates that the locking
1
pin is engaged in the quadrant, right located into
1
place (Fig. D).
Fig. D parts description see below:
D-1 Quadrant
D-2 Locking Pin
WARNING:
out the adjustment only when the cutting blades are
at a standstill. Never touch the blades while making
adjustments.
WARNING:
the tool and fit the blade scabbard before moving the
cutting blade to the storage position or from the storage
position to the normal working position.
CONNECTING/REMOVING THE HEDGE TRIMMER
ATTACHMENT TO THE POWER HEAD
This hedge trimmer attachment is designed for use with
EGO 56V LITHIUM-ION Power Head PH1400E. Besides top
cutting, there is a side-cutting position in the hedge trim-
mer shaft for connecting with the power head (Fig. E). Detail
working techniques please see "WORKING TECHNIQUES"
section in this manual.
Fig. E parts description see below:
E-1 Top Cut Position
E-2 Side Cut Position
See "INSTALLING AN ATTACHMENT TO THE POWER
HEAD " section in the power head PH1400E operator's
manual for connecting the hedge trimmer to the power
head.
To reduce the risk of injury, carry
To reduce the risk of injury, always stop