®
Operating instructions Midwest
Rhino XE
67 16 786 D3758.201.01.01.02
8
Maintenance
Elastomers, e.g. O-rings, must be replaced depending on their
degree of wear.
8.1
Replacing the sealing washer
If water/air leaks out between the motor and the hose connection,
replace the sealing washer.
1.
2.
A
3.
B
Disconnect the motor from the supply hose.
Use a probe etc. to remove the defective sealing washer (B)
from the rear of the motor.
Attach the new sealing washer, observing the position of the
tubes and contact pins and press it to the stop.
IMPORTANT: The bead (A) on the sealing washer faces the
supply hose.
8 Maintenance
33