SPORTSTECH CX 650 Manual Del Usuario página 59

Operation guide:
1. Sleep Mode:
The computer will enter the sleep mode when there is no signal input and no keys be pressed after 4 minutes. You can
press any key to wake up the computer.
Error Message:
E1 (ERROR 1):
Normal state:
During workout, when the monitor did not get the count signal from the gear motor more than 4 seconds and
check under successive 3 times then the LCD will show E1.
Power on state:
E2 (ERROR 2):
When the monitor read the memory data, if the I.D. code is not correct or the memory IC damages then the
monitor will show E2 immediately at power on.
E3 (ERROR 3):
After 4 seconds by start mode, the computer detects the faulty motor did not leave the zero point then the LCD
bar displays "E3".
LCD Workout Graphics
PRESET PROGRAM PROFILES:
PROGRAM 1
MANUAL
PROGRAM 4
ROLLING
PROGRAM 7
RAMP
PROGRAM 10
RANDOM
PROGRAM 13
PRECIPICE
The gear motor will return to zero automatically, when the signal of motor cannot be detected for more
than 4 seconds then the gear motor's driver will be cut off immediately and show the E1 on the LCD
display. All the other digital and function mark are blank, and the output signals are cut off also.
PROGRAM 2
STEPS
PROGRAM 5
VALLEY
PROGRAM 8
MOUNTAIN
PROGRAM 11
PLATEAU
57
PROGRAM 3
HILL
PROGRAM 6
FAT BURN
PROGRAM 9
INTERVALS
PROGRAM 12
FARTLEK