Time & Date Programming; Quick Exit; Door Chime (Entry/Exit Beeps); Trouble Conditions - DSC Power Serie Manual De Instruccion

Time & Date Programming
Press , plus your Master Access Code. The Program or System indicator will begin to flash, and the Armed ( ) indi-
cator will turn on.
Press to select Time and Date. The Ready ( ) indicator will turn on.
When using the LCD5500, use the
Enter the time in 24-hr format (HH:MM), followed by the date (MM:DD:YY). Press

Quick Exit

If the system is armed and you need to exit, use the Quick Exit function to avoid disarming and rearming the system. Press
and hold the Exit key for 2 seconds or press
door. When the door is closed again, the remaining exit time is cancelled.
Door Chime
(Entry/Exit Beeps)
To turn the door chime function on or off, press and hold the Chime key for 2 seconds or press

Trouble Conditions

When a trouble condition is detected, the Trouble ( ) or System indicator will turn on, and the keypad will beep every 10
seconds. Press the
indicator will flash. The corresponding trouble will be represented by numbers 1-8.
Trouble Condition
LED/DIGIT
1 Service Required
2
Loss of AC Power
3 Telephone Line Fault
4
Failure to Communicate
5
Sensor (or Zone) Fault
6
Sensor (or Zone) Tamper
7
Sensor (or Zone) Low Battery
8
Loss of Time & Date

Bypassing

To bypass a sensor, press
Enter the 2-digit number for the sensor to be bypassed (i.e. 03 for sensor number 3). To bypass an additional sensor, enter
another 2-digit entry for that sensor.
For the LCD5500, use the
scroll keys to find the menu option and press
key to silence the beeps. Press
Comments
If the building and/or neighborhood has lost electrical power, the
system will continue to operate on battery for several hours.
The system has detected that the telephone line is cut.
The system attempted to communicate with the monitoring sta-
tion, but failed. This may be due to Trouble 3.
The system is experiencing difficulties with one or more sensors
on the system.
The system has detected a tamper condition with one or more
sensors on the system.
If the system has been equipped with wireless sensors, one or
more has reported a low battery condition.
If complete power was lost (AC and Battery), the time and date
will need to be re-programmed.
. The bypass or system indicator will flash.
Press
scroll keys to find the specific sensor and press
. You now have 2 minutes to leave the premises through your exit
to view the trouble condition. The Trouble ( ) or System
to exit. The bypass or system indicator will stay on.
10
to select.
to exit programming.
.
Action
Call for service
Call for service
Call for service
Call for service
Call for service
Call for service
Call for service
Call for service
to bypass.