Initial Use - Beurer Elle FCE 70 Instrucciones Para El Uso

6. Initial use

• Place the device on a flat, secure, even and water­
resistant surface or table.
Important
• Only operate the device with distilled water! Do not use
tap water, as this can cause the build-up of limescale in
the device and impair its functionality and service life.
Do not use any oils, herbs or other flavouring agents
instead of water.
• Fill the supplied measuring jug with distilled water
(no more than 150 ml).
• Press the open button of the cover flap on the device.
• Using the measuring jug, pour the distilled water slowly
and carefully into the opening of the water tank on the
top of the device. Take care not to spill any water on
the surface of the device. The fill level display on the
device shows the current water level. When filled to the
maximum level, the amount of water is sufficient for a
treatment lasting approximately 20 minutes. If you fill the
device with more than 150 ml of water, the excess water
flows directly into the water collection container.
• Close the cover flap. Press the cover flap downwards
until it clicks into place.
• Adjust the angle of the nozzle to the required height.
Important
Do not adjust the nozzle when the device is in use! You
could sustain burn injuries to the hand.
• Wash your face with a damp cloth before using the
device.
11
Distilled water