Maintenance
To re-install the oven door
Storage drawer
24 English
NX58K3310SS_AA_AC_DG68-00773A-04_EN+MES+CFR.indb 24
1. Firmly grasp both sides of the door at
the top.
2. With the door set at the same angle as
the removal position (about 5 degrees
from vertical), slide the hinge arms into
the hinge slots at the bottom of the
door.
3. Open the door fully. If you cannot open
the door fully, the hinge arms are not
properly in the hinge slots.
4. Lock the hinge arms by pushing them
up against the front frame of the oven.
5. Close the door, and make sure it opens
and closes normally.
1. Pull out the drawer and remove any
stored content.
2. While supporting the drawer, pull it out
until the top of the drawer sides come
out of the two nylon drawer guides.
Then, lift to remove the drawer.
3. Clean the drawer with warm, soapy
water. Rinse and dry thoroughly.
4. Place the top of both drawer sides in
the openings on the two nylon drawer
guides and push in enough to support
the drawer.
5. Replace any stored content, and then
push in the drawer while slightly lifting
the front to close it.
Troubleshooting
If you encounter a problem with the range, check the tables starting below, and
then try the suggested actions.
Checkpoints
Gas safety
Problem
Possible cause
You smell gas.
The surface burner
knob is not in the OFF
position and the burner
is not lit.
There is a gas leak.
Action
Turn the burner knob to OFF.
Clear the room, building, or area of
all occupants.
Immediately call your gas supplier
from a neighbor's phone. Do not call
from your phone. It is electrical and
could cause a spark that could ignite
the gas. Follow the gas supplier's
instructions.
If you cannot reach your gas
supplier, call the fire department.
2/1/2018 5:18:56 PM