In-Place Sanitization; Routine Maintenance - Vollrath Stoelting SCBA Serie Manual Del Usuario

clip the cold drink restrictor on the end of the spigot. To remove
or disassemble place thumb on cold drink restrictor tab and
lightly pull down to remove.

6. 5 IN-PLACE SANITIZATION

1 Prepare 2 gallons of Stera-Sheen sanitizing solution
according to the manufacturer's instructions.
2 Pour the solution into the bowls.
3 Using a suitable brush, wipe the solution onto all parts
above the level of the solution and on the underside of the
cover.
4 Install the cover and operate the dispenser in order to allow
the solution to be stirred for about 2 minutes. Drain the
sanitizing solution from the bowls through the spigots and then
dispose of it.
5 Remove the flow restrictor from the bowl (see figure 8).
6. 6 FREEZE DOWN & OPERATION
1 Place a container under the spigot and rinse the bowl with
mix to flush out any remaining sanitizing solution.
2 Fill the bowls with chilled mix.
3 Turn on the main power.
4 Press the power/standby button then press and hold the
freeze button for 1 second to start freezing product.
5 Once freezing, the snowflake icon displays on the screen
and the density bars are displayed.
6 Momentarily press the freeze or clean button to increase or
decrease density.

7 ROUTINE MAINTENANCE

1 Every day: inspect the dispenser and check for leaks of
product from the gaskets. If you notice leaks, first make sure
that the components of the dispenser are properly installed,
then check that the gaskets do not require lubrication and
finally that they are not worn or damaged. If they are, replace
them with original spare parts from the manufacturer.
2 Every month: remove the dust from the condenser filter at
the back of the machine (see figure 14).
ATTENTION
Beware of the condenser fins as they are sharp.
3 In case of strange noise or failure, disconnect the dispenser
from the power source and call for service.
7. 1 MAINTENANCE (TO BE CARRIED OUT BY
QUALIFIED SERVICE PERSONNEL ONLY)
IMPORTANT
In order to prevent damage to the dispenser, the plastic
parts must only be lubricated with Total Blend or with
another food grade sanitary lubricant compatible with
plastic parts.
Annually: Remove all the panels and clean the inside of the dis-
penser including the base and the inside of the panels.
Never remove the anti-condensation material wrapped around
the evaporator outlet tube (the copper tube located to the right
of the geared motor). If said material is missing or lost, replace
with original spare parts from the manufacturer.
9
figure 14