Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
The opening and closing stopper must be installed before programming the travel (see the
operator manual).
1 Press ENTER, with the
display showing
CL88
rSXX
(rSº
 8,
rSº
â 8,
rS8º
? , etc).
5
T294E
8
Start opening of leaf 1
with ST1:
I
II
11
Start opening of leaf 2
with ST1:
I
II
14
Start closing of leaf 2
with ST1:
I
II
17
Start closing of leaf 1
with ST1:
I
II
20
T294O
22
Gate open/close programming (all cases)
2
or
rS8º
@ ,
6
With encoder and/or obstacle detection
without slowdown, the gate carries out the
approach operation (opening for 4 seconds
and then closing to programme the closing
point). It also carries out slowdown in
accordance with the value CA.
In other cases, close the gate before starting
programming.
9
Start slowdown of leaf 1
with ST1
(only with CA01 or CA02):
I
II
U294
12
Start slowdown of leaf 2
with ST1
(only with CA01 or CA02):
I
II
U294K
15
Start slowdown of leaf 2
with ST1
(only with CA01 or CA03):
I
II
U294N
18
Start slowdown of leaf 1
with ST1
(only with CA01 or CA03):
I
II
U294T
21
22
T294P
3
S294B
7
10
Finish opening of leaf 1 with ST1:
In any case, this is carried
out automatically when
the
opening
(with C701, C703, C704
or C705) or the FCA
(with C702 or C704) is
reached.
U294I
13
Finish opening of leaf 2 with ST1:
In any case, this is carried
out automatically when
the
opening
(with C701, C703, C704
or C705) or the FCA
(with C702 or C704) is
reached.
U294L
16
Finish closing of leaf 2 with ST1:
In any case, this is carried
out automatically when
the closing stopper (with
C701, C703 or C704) or
the FCC (with C702,
C704
or
reached.
U294R
19
Finish closing of leaf 1 with ST1:
In any case, this is carried
out automatically when
the closing stopper (with
C701, C703 or C704) or
the FCC (with C702,
C704
or
reached.
U294U
The anti-trapping safety system continues to run
during programming operations.
Pedestrian opening is programmed using F3,
meaning the travel for this pedestrian opening
does not need to be programmed.
If an obstacle is detected during programming in
up-and-over operation with C5 Closing photocell
T294R
enabled, this will be considered the point from
which the photocell shadow function should be
enabled. This only works with Collective
Opening (A901).
4
S294C
The procedure with a
swing
gate
below.
Proceed
manner for sliding gates or
up-and-over doors.
T294H
stopper
I
II
stopper
I
II
I
II
C705)
is
I
II
C705)
is
T294D
is
shown
in
the
same
U294J
U294M
U294S
U294V
Publicidad
Tabla de contenido
