Deactivating The Room Monitor Remotely; Setting The Handset; Quickly Accessing Numbers And Functions - Siemens Gigaset C59H Manual Del Usuario

When the room monitor function is acti-
vated, the idle display appears as shown
below:
i V
07:15 am
Á
INT 1 Oct 22
Room Monitor
9725551234
Off Options
Changing the set destination
number
É
¢ ¢
v
Room Monitor
¤
Enter and save number as described
under "Activating the room monitor and
entering the destination number"
¢
( page 36).
Cancel/deactivate room monitor
Press the end call key a to cancel the call
when the room monitor is activated.
In the idle status, press the display key
to deactivate room monitor mode.
Deactivating the room monitor
remotely
Prerequisites: The phone must support tone
dialing and the room monitor should be set
for an external destination number.
¤
Accept the call from the room monitor
and press keys 9 ;.
The call ends immediately and the room
monitor function deactivates. There will be
no further room monitor calls.
To reactivate the room monitor function
with the same phone number:
¤
Reactivate and save with
¢
( page 36).
§Off§
§Save§

Setting the handset

Your handset is preconfigured, but you can
change the settings to suit your individual
requirements.
Quickly accessing numbers
and functions
You can assign a number from the directory
to each of the digit keys Q and 2 to
O.
The left and right display keys have a func-
tion pre-selected by default. You can change
¢
the assignment ( page 38).
The number is then dialed or the function
started by simply pressing a key.
Assigning digit keys (quick dial)
Prerequisite: You have not yet assigned a
number to the digit key.
¤
Press and hold the digit key.
or:
Press the digit key briefly and press the
§QuickDial§
display key.
The directory opens.
¤
Select an entry and press
The entry is saved to the appropriate digit
key.
Please note
If you delete or edit the entry in the direc-
tory at a later date, this will not affect the
assignment to the number key.
Setting the handset
§OK§
.
37