CASUALPLAY BiCare Fix Manual De Instrucciones página 22

Tabla de contenido

Idiomas disponibles

of the harness (fig.11).

• To open the safety harness buckle, press the red button found in the middle of the

buckle. Next, separate the two metal parts that were fastened to the buckle.

• Once the harness is placed on the child, bring the two metal parts together and insert

them into the buckle. It will click when correctly fastened (fig.12).Adjust the harness to

fit the child's body by pulling the harness adjustment strap (fig.13). The straps should

not be too tight or too loose.

IMPORTANT: Make sure that the harness straps are not

Installing the Bi Care Fix

Installing the Bi Care Fix as group 0+ (0-13 kg)

• Place the Bi Care Fix base on the vehicle seat, and pull the ISOFIX connectors out

(fig.04). Consult the section referring to adjusting the ISOFIX connectors.

• Fasten the ISOFIX connectors of the base to the ISOFIX anchors of the vehicle seat,

and make sure that a green indicator appears on both ISOFIX connectors of the base

(fig.05). Press the base against the vehicle seat, to finish fitting it.

• Adjust the height of the support bar (fig.03), to do this consult the section on adjusting

the length of the support bar.

• Release the seat locking system, and position the Bi Care Fix seat facing backwards.

• To lock the seat to the base, press the seat locking button (red button). The Bi Care Fix

fastener indicator will turn green (fig.14).

• Place the child in the Bi Care Fix seat and fasten him in with the harness. Consult the

section on adjusting the harness to correctly secure the child in the Bi Care Fix.

NOTE: If the Bi Care Fix is installed as group 0+, only the reclining position

3 can be used.

WARNING: Make sure that the seat is correctly fastened to the base.

Installing the Bi Care Fix as group 1 (9-18 kg)