Adjusting The Harness - CASUALPLAY BiCare Fix Manual De Instrucciones

3 can be used.
• Pull the handle on the mechanism for changing the reclining position, found on the front
part under the seat (fig.07), and place the seat in the required position by pressing the
Bi Care Fix forwards or backwards. Once it has reached the required position, release
the handle of the reclining mechanism. It will click when correctly fastened into place.
NOTE: Make sure that the seat is locked into one of the three reclining
positions, and is not halfway between two positions.
NOTE: If the Bi Care Fix is installed as group 0+, only the reclining position
3 can be used.
Fitting/removing the seat from the ISOFIX base
• The Bi Care Fix can be installed facing forwards or backwards, depending on the mass
group.
o Group 0+ (0-13 kg). Facing backwards.
o Group l (9-18 kg). Facing forwards.
• Fit the ISOFIX guides on the vehicle seat, if necessary.
• Place the Bi Care Fix base on the vehicle seat.
• Before placing the Bi Care Fix seat in one of the two possible positions, the seat locking
mechanism must be free. To do this, keep the seat locking button (red button) pressed
down while pressing the seat release button (fig.08).
• Place the Bi Care Fix in one of the two possible positions, fitting the rods on the bottom
of the seat into the anchor points on the base (fig.09).
• To lock the seat to the base, press the seat locking button (red button). The fastener
indicator of the Bi Care Fix will turn green (fig.10).
WARNING: Make sure that the seat is correctly fastened to the base. To
do this, check that the two rods, found under the seat, have been correctly
fastened to the locking system.
• If you want to separate the Bi Care Fix seat from its base, you need to release the
locking system. Keep the seat locking button (red button) pressed down while pressing
the seat release button (fig.08). Pull the Bi Care Fix seat upwards.

Adjusting the harness

• To adjust the harness the first step is to check that the harness is at the correct height
at the child's shoulders (fig. 02). To reach the correct height, adjust the Bi Care Fix
headrest.
• Loosen the harness pressing the harness adjustment button and pulling the chest part
19