Fanimation DISTINCTION D1 Serie Manual Del Usuario página 18

How to Operate Your Ceiling Fan (Continued)
5. If you have multiple fans and want to program each fan
to separate handheld controls, connect one fan at a time to
their power supply in the ceiling and follow Step 1 of the
remote control set up process below. Before you connect
the second fan to its power supply in the ceiling, you must
disconnect the first fan that was wired and programmed
from the power supply in the ceiling. Repeat these steps
for each fan that you would like to program to a separate
handheld remote. Please note that the wall switch that
controls the power to your fan(s) should be in the off
position until you are ready to program your handheld
remote(s).
6. Remote Control Setting and Speed (RPM)
Setting Process : (Figure 4)
1) After installing and wiring the unit, restore power to
your fan by ensuring that the breaker and wall switch
that controls the power supply is moved to the on
position, press and hold the "SET" button inside of the
battery compartment of the handheld remote control for
1-3 seconds.
2) You must press the "SET" button within 30 seconds of
restoring power to the fan.
3) When restoring power to your fan at the wall switch
and breaker, DO NOT press any button(s) on the
handheld remote control before pressing the "SET"
button, otherwise the fan will fail the learn procedure.
4) If you press any button(s) on the handheld remote
control before pressing the "SET" button, please turn the
wall switch that controls the power to the fan to the o
position then on again, and start the process beginning
with Step 1 above.
5) When you press the "SET" button, the fan will make
one musical sound and light blink once if with light and
start to run beginning the control set up process.
6) DO NOT press any button(s) after pressing the SET
button while the fan is programming or it will fail to
program.
7) The fan will run in both directions (forward and
reverse) for approximately 5-7 minutes.
8) When the fan stops running after approximately 5-7
minutes, the fan will make two musical sounds and light
blink twice if with light that means that the handheld
remote control and speed set up process is complete.
9) The fan is now ready for normal use.
Dip Switch
NOTE: If you want to change the blades: turn
18
SET
Figure 4