Auto Off Function - UFESA DH4020 Manual De Instrucciones

When the defrost function is enabled,
you may hear a sound of flowing
coolant. This is normal.

AUTO OFF FUNCTION

If the water tank (5) is removed, improperly installed or
overfilled, water level control switch turns the appliance
off.
If the water tank is removed or
incorrectly installed, the appliance turns
off. The display shows P2 code, water
tank full indicator lights up, and the appliance
makes 8 short beeps.
If the water tank is completely full when
the appliance is running, the compressor
turns off and the fan continues to
operate for 30 seconds. Then the appliance
makes 8 short beeps, water tank full indicator
lights up and the display shows P2 code.
If the operating appliance is switched
off after the water tank is full, it will
automatically start when empty water
tank is installed correctly. After 3 minutes the
appliance will automatically restart in
accordance with the last used settings.
Remove the collected water
There are two methods of removing the collected
condensate:
USING WATER TANK
Water may be collected in the water tank (5).
The dehumidifier automatically turns off when the water
tank (5) is full.
If the water tank is completely full when
the appliance is running, the compressor
turns off and the fan continues to
operate for 30 seconds. Then the appliance
makes 8 short beeps, water tank full indicator
lights up and the display shows P2 code.
1
Grab the holders on the sides of the water tank (5)
with both hands and carefully slide it out.
When ejecting the water be careful not
to splash the water!
Do not place the full tank on the floor
or other surfaces, as the bottom of the
tank is uneven and water may spill!
2
Empty the tank as shown on the picture.
3
Install the tank in the appliance so that it securely
and properly fits in its place.
The appliance will not operate with
missing or incorrectly attached water
tank.
When installing the water tank make
sure that its mounting location is dry.
If not, let it dry.
When installing/removing the water
tank, do not touch any parts inside the
appliance!
● After correct installation of the water tank, the
dehumidifier starts automatically after 3 minutes in
accordance with the last used settings.
Do not remove the water tank during
operation. This may cause water flow
out from the drain opening.
Do not use the drain tube when using
K
a water tank. If the tube is connected,
the water flows through it on the floor
rather than into the tank.
THROUGH THE DRAIN TUBE
If the dehumidifier is operated at very high levels of
humidity, water from the tank must be drained more
often. In this case, it is convenient to use continuous
drainage.
Water may be automatically drained from the appliance
through an installed drain tube with an inner diameter
of 13,5 mm (not included).
L