Mutsy IGO Serie Manual De Instrucciones página 16

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

· Check that the chair has been attached properly by trying to lift it from
the frame. NB! The frame cannot be folded with the seat facing back-
wards!
Remove the seat (q)
· Slide the unlocking buttons upwards until you hear a click on both
sides. Be careful! The seat is now unlocked; the red section on the frame
attachment points are now visible. The seat can vertically be removed
from the attachment points.
Adjust the back support (r)
· Pull the button at the back of the seat upwards and hold it upwards.
· The back support has 4 positions. Place the back support in the desired
position and release the button to lock the position.
Attach and remove bumper bar (s1)
· To secure the front bumper, press the ends of the bumper into the re-
cesses intended for this purpose on the seat until you hear a click.
· Press the unlock buttons on both sides of the front of the bumper bar
to remove the bumper bar from the chair.
Adjust the leg support (s2)
· Lift the leg support to place it upwards.
· Push the buttons on both sides of the leg support and push the leg
support downwards to lower it.
Fully reclined position (t)
· The seat has a fully reclined position to make the seat suitable for children
from birth ! The use of a suitable pram body is always recommended and
preferred for children from birth up to the age that your child can sit up
unassisted.
· To put the seat in the fully reclined position, put the leg rest in its high-
est position (t1) and the backrest of the seat in its most reclined posi-
tion (t2).
· Release the two press studs on each side of the seat (t3). Open the zip-
per around the leg support (t4). There is a fabric side support in the
pocket behind the leg support, which you can pull out. Now you can
put the side support up and attach the two press studs on each side
onto the plastic shell of the seat (t5). The press studs of the seat cover
can now be attached to the press studs of the side support.
! The hood of the seat needs to be in the first upright position (not exten-
ded). There are 2 straps on either side of the seat to keep the canopy
10

Publicidad

Tabla de contenido
loading

Tabla de contenido