The Maxi-Cosi Car Seat - Mutsy IGO Serie Manual De Instrucciones

The 5-point safety harness (x1, x2)
· Place your child in the pushchair and make sure that the legs of your
child are placed on each side of the leg piece.
· Make sure that the hip and shoulder belt is positioned correctly over
your child and place both plastic clamps in the central part of the har-
ness attached to the leg piece (x1).
· To adjust the length of the shoulder straps, loosen the shoulder protec-
tors from the belt by undoing the velcro. This will reveal the belt buck-
les. Adjust the length by sliding the buckles along both shoulder straps
until your child is comfortably secure. After adjusting, press down the
velcro on both sides to relock the shoulder protectors in place.
· The back support contains three positions for the shoulder belts. To ad-
just the position, open the panel behind the back support (x2). Loosen
the shoulder belts by moving the attachment rings through the open-
ings. Move the attachment rings through the desired openings so that
the shoulder belts are positioned properly and click the panel back.
· Regularly check the length and position of the belts and adjust, where
necessary.
Maxi-Cosi car seat
· The Maxi-Cosi car seat adapters are suitable for use with the Maxi Cosi
Mico: 5-22 lbs. 19-22 in. (2,2-10 kg, 48-74 cm) and Maxi Cosi Prezi: 4-30 lbs.
<29 in. (1.8-13.6 kg, <74cm).
· Always observe the instructions in the manual of your Maxi-Cosi car
seat before you start using the car seat.
· Make sure that the frame has fully been unfolded and the brake blocked
during all actions indicated below.
Place the Maxi-Cosi adapters on the frame (y)
· The adapter marked with 'R' is placed on the right side of the frame, the
adapter marked 'L' is placed on the left side.
· Slide the adapters in the attachment parts and press solidly until you
hear a click.
Place the Maxi-Cosi car seat on the adapters
· Orientate the Maxi-Cosi car seat such that it is directed rearwards on the
frame.
· Hold the Maxi-Cosi car seat with the central hinge points of the support
bar directly above the adapters.
· Lower the Maxi-Cosi car seat and press solidly into the adapters un-
til you hear a click.
· Check that the Maxi-Cosi car seat has been placed horizontally and has
12